Kenwood KDC-BT950DAB Mode D'emploi page 28

Bluetooth®
(for
Improve the voice quality
While talking on the phone...
1
Press the volume knob to enter [FUNCTION].
2
Turn the volume knob to select an item (see the following table), then
press the knob.
3
Repeat step 2 until the desired item is selected or activated.
4
Press and hold to exit.
To return to the previous setting item, press
[MIC GAIN] [–10] to [+10] ([–4]): The sensitivity of the microphone increases as the
number increases.
[NR LEVEL] [LEVEL –5] to [LEVEL +5] (LEVEL [0]): Adjust the noise reduction level
until the least noise is being heard during a phone conversation.
[ECHO CANCEL] [LEVEL –5] to [LEVEL +5] (LEVEL [0]): Adjust the echo cancellation
delay time until the least echo is being heard during a phone conversation.
• Call quality may depend on mobile phone.
Make the setting for answering a call
1
Press to enter Bluetooth mode.
2 Turn the volume knob to select [SETTINGS], then press the knob.
3 Turn the volume knob to select [AUTO ANSWER], then press the knob.
4 Turn the volume knob to select the time (in seconds) for the unit to
answer the call automatically, then press the knob.
[01] to [30], or select [OFF] to cancels. (Default: [OFF])
5
Press and hold to exit.
To return to the previous setting item, press
20
ENGLISH
/ /
.
Default: [XX]
.
)
Make a call
You can make a call from the call history, phonebook, or dialing the number.
Call by voice is also possible if your mobile phone has the feature.
1
Press to enter Bluetooth mode.
"(First device name)" appears.
• If two Bluetooth phones are connected, press
other phone.
"(Second device name)" appears.
2 Turn the volume knob to select an item (see the following table), then
press the knob.
3 Repeat step 2 until the desired item is selected/activated or follow the
instructions stated on the selected item.
4
Press and hold
To return to the previous setting item, press
[CALL HISTORY] (Applicable only if the phone supports PBAP.)
1 Press the volume knob to select a name or a phone number.
• "I" indicates call received, "O" indicates call made, "M" indicates call
missed.
• Press DISP to change the display category (NUMBER or NAME).
• "NO DATA" appears if there is no recorded call history or call number.
2 Press the volume knob to call.
again to switch to the
to exit.
.