Identification Number; Lock Function - IMG STAGELINE TXS-865HSE Mode D'emploi

5.1.4 Identification number

To enable the REMOSET transmission between the
transmitter and the receiver unit, match their iden-
tification numbers .
1) Keep the button SET (4) pressed until the display
briefly shows
mode (group indication starts flashing) .
2) Press the button SET repeatedly until the display
shows and the current identification number
( ... or ) .
3) In the setting range
the button − (5) to search in descending order
or press the button + (6) to search in ascending
order . Use the corresponding button to set the
transmitter to the identification number of the
receiver unit (the transmitter will only respond
to the REMOSET signal of this receiver unit) or
select (the transmitter will respond to the
REMOSET signal of any receiver unit) .
4) Press the button SET to confirm . The display
briefly shows
normal mode .

5.1.5 Lock function

When the lock function has been activated, you
will no longer be able to switch off the transmitter .
From the setting modes, you will only be able to
activate the mode for the lock function in order to
deactivate the lock . When the transmitter is locked
and you set the on / off switch (2) to OFF or press
a button, the display will show
Note: Do not leave the on / off switch in the position
OFF when the transmitter is locked; the display backlight
will not be extinguished automatically and there will be
unnecessary power consumption .
Activating the lock
1) Keep the button SET (4) pressed until the display
briefly shows
mode (group indication starts flashing) .
2) Press the button SET repeatedly until the display
shows (lock off) .
3) To activate the lock, press the button + (6) . The
display shows
4) Press the button SET to confirm . The display
briefly shows
normal mode .
All rights reserved by MONACOR
reproduced in any form or by any means for any commercial use.
and then the group setting
, ...
. The unit will return to the
(lock on) .
and then the group setting
.
. The unit will return to the
INTERNATIONAL GmbH & Co. KG. No part of this instruction manual may be
®
Deactivating the lock
1) Make sure that the on / off switch (2) is set to ON .
2) Keep the button SET (4) pressed until
flashing in the indication
3) To deactivate the lock, press the button − (5) .
The display shows
4) Press the button SET to confirm . The display
briefly shows
normal mode .
press
6 Specifications
Carrier frequency range: 506 – 542 MHz
Frequency stability: . . . . ±0 .005 %
Transmission power: . . . 10 mW
Audio frequency range: 40 – 18 000 Hz
Ambient temperature: . 0 – 40 °C
Power supply: . . . . . . . . 2 × 1 .5 V battery of size
Operating time: . . . . . . > 25 h (for alkaline
Dimensions: . . . . . . . . . 68 × 172 × 21 mm
Weight: . . . . . . . . . . . . 77 g (w/o batteries)
Microphone connection: mini XLR, 3 poles
1 = ground
2 = audio signal
1 3
3 = 5 V operating voltage
2
Subject to technical modification .
.
.
. The unit will return to the
table on page 20
☞
AA (not supplied)
batteries 3400 mAh)
for the microphone
starts
11