LPG Wellbox S Guide D'installation Et D'utilisation page 18

EN
roll heads maintenance
For reasons of hygiene, the treatment heads must be cleaned regularly
before and after every use, with the heads disconnected, using the supplied
wipes or wipes soaked with an antiseptic, bactericidal and fungicidal solution.
To clean the Roll heads
1 . Hold the head by the roller side.
Remove the rollers by pushing them out.
2 . Remove the seal from treatment chamber.
3 . Carefully clean the treatment chamber, the seal
and the rollers with a wipe.
4 . Put the seal back in place.
5 . Push the rollers back in until you hear a "click".
To clean the Roll head
1 . Holding the head in one hand, unclip the
protective parts from each of the rollers
and clean them using a wipe.
2 . Remove the two seals by delicately
removing them from their groove and then
clean them carefully using a wipe.
3 . Clean the treatment chamber and the rollers
with a wipe.
4 . Clip the protective parts to the forked seals and
place both parts into the head. Apply slight pres-
sure to the grooves to put everything into place.
M i n c e u r & A n t i - â g e
1. 2.
3. 3.
5.
4.
1. 1.
2. 3.
4.
16
EN
lift heads maintenance
For reasons of hygiene, the treatment heads must be cleaned regularly
before and after every use, with the heads disconnected, using the supplied
wipes or wipes soaked with an antiseptic, bactericidal and fungicidal solution.
To clean the Lift head
1 . Hold the Lift head or . Pick up the disassembly tool
for each head and insert it, on its tapered side, in the removable flap area until
you hear a "click".
2 . Pull the tool out; the flap will come out as well.
3 . Dismount the flap from the tool and clean it carefully with a disposable
antiseptic wipe.
4 . Hold the tool on its flat sides and mount the flap back on the tool.
5 . Insert both in the treatment head until the bottom of the head is reached.
1.
M i n c e u r & A n t i - â g e
:
or , specific
2.
4.
17
3.
5.