Power Supply - LPG Wellbox S Guide D'installation Et D'utilisation

EN
installation
Open the device by
pressing on the button
located in front.
To connect the hose to the machine, do as follows:
Insert the hose with the arrow
upwards, as indicated in the photo.
side. To disconnect it, pull carefully. Never turn or
force the connecting hose.
Then, you may connect the treatment head of your choice to the hose:
Choose one of the heads and then connect it to the
hose by lining up the arrows on the head and hose.
Repeat this process whenever you want to change
the treatment head.
After use, the hose is easily stored by coiling it in
the designed area, as shown in the picture.
To increase the life expectancy of your flexible
hose, it recommended though not to leave it rolled
up during a prolonged period.
M i n c e u r & A n t i - â g e
Store the four
treatment heads in the
locations specifically
designed for that
purpose. Each head's
dedicated storage area
is indicated with
a pictogram.
(in relief)
The connecting hose may be joined on either
12
EN

power supply

The Wellbox [S] device is supplied with a power supply box that contains:
®
• A main power supply. Input 100-240 VAC,
50/60Hz – Output 24 VDC
• Four power socket adapters
To connect your machine, do as follows:
1. Select your country's specific adapter and fit it onto the power supply.
If the adapter provided does not fit into your outlet, consult an
electrician to identify the proper solution.
1.
2. Insert the male jack into the female socket located at the rear of
Wellbox ® [S].
2.
3. Connect the power supply to a wall outlet. The green mains LED
will be illuminated.
3.
The website mentioned on the box is inactive.
Please visit www.wellbox.com
The power supply is an integral part of your device.
It is prohibited and dangerous to disassemble the power supply
or use a power supply other than the one provided with the device.
M i n c e u r & A n t i - â g e
13