LPG Wellbox S Guide D'installation Et D'utilisation page 17

EN
starting up
Before using the Wellbox ® [S] device, we recommend reading the installation
instructions.
1. After connecting the power (see page 14), press the
the device. The control panel lights up. Before starting the treatment and
according to the instructions in this Installation and User Guide, you must select:
• The intensity (Power)
• The continuous or rhythmic treatment program (Select)
• The duration of treatment (Time)
When you use the machine for the first time, all parameters are set at the lowest
values:
- Minimum intensity at
. Press on
- Suction mode on Continuous
/ / (low/medium/high).
- Time at 6' . Press or
06'00
2. Select the head to use and then adjust the power settings, continuous or
rhythmic program, and duration by referring
3. Press to start the treatment. If the Roll head
start
stop
moving forward when the treatment begins. A lit arrow indicates the head's
moving direction. Press the trigger to reverse the direction. The lit arrow will also
change (see page 11).
4. You can interrupt the treatment at any time and resume when you want by
pressing .
start
stop
5. To close the Wellbox [S] device after use:
®
- Connect the Roll head to the hose.
- Roll the hose into the tube designed for this purpose (twice around).
- Place the Roll head in the location next to the control panel. Store the other
heads in their location in the top lid.
Your Wellbox [S] device automatically turns off after five minutes of
®
non-use
M i n c e u r & A n t i - â g e
button to turn on
to increase
. Press on to switch to rhythmic mode
to select the required duration for treatment.
to the Instructions poster.
is connected, the rollers are
14
EN
maintenance
It is important to clean your machine regularly, for hygienic
reasons, to keep it in good working order and guarantee the length of
its useful life. Disconnect the machine before any cleaning operation.
Changing the protection filter
The Wellbox [S] device contains a protective filter . It is recommended that this filter
®
be replaced monthly to ensure the good working order of the unit.
To replace the filter:
Disconnect the power from the wall outlet.
1.
Unscrew the cap a quarter-turn to the left, as indicated in the photo, and then pull it
towards you.
3.
Remove the used filter by detaching
and discarding the cap.
M i n c e u r & A n t i - â g e
2.
4.
Place the new filter (only one at
a time) by folding the two pins and
placing the cap back on.
15