Before Initial Use; Charging Up The Battery - DSPro 09123 Mode D'emploi

Before Initial Use

•
•
•

Charging Up the Battery

■
Before initial use the battery should be fully charged, so that it
reaches its full capacity.
1. Plug the USB cable into the USB mains adapter and then
2. Plug the USB cable with the Micro B connector into the con-
3. Place the handheld device into the base station. The hand-
4. The battery is fully charged when the charge control lamp
09123_DE-EN-FR-NL_A6_V1.indb 19 09123_DE-EN-FR-NL_A6_V1.indb 19
Before using the device, remove all packaging materials
and any labels that may be on the device and are used for
protection during transportation or for advertising. Never re-
move the rating plate and any possible warnings!
There may still be some production residues on the mouth-
pieces. To avoid harmful effects to your health, clean them
thoroughly before you fi rst use them (see the "Cleaning and
Storage" chapter).
Charge the battery (see the "Charging Up the Battery"
chapter).
PLEASE NOTE!
The device should not be charged via a computer, because
the high charging current could damage the computer.
plug this into an easily accessible plug socket.
necting socket on the base station.
held device is charged. The charge control lamp fl ashes.
is permanently lit.
19 EN
08.11.2018 12:32:03 08.11.2018 12:32:03