Disposal Information - WOLFF AKKU JUNIO-STRIPPER 18V-230 V SET Traduction Du Mode D'emploi Original

EN

8.0 Disposal information

Disposal
The machine, accessories and packaging should be sorted
for environmental-friendly recycling.
Only for EC countries:
Do not dispose of power tools into household
waste! According the European Guideline
2002/96/EC for Waste Electrical and Elect-
ronic Equipment and its implementation into
national right, power tools that are no longer
usable must be collected separately and disposed of in an
environmentally correct manner.
Subject to change without notice
9.0 Notes on various fl oor coverings
Operating instructions
► Do not place the power tool until a load that
causes it to stop.
The AKKU JUNIO-STRIPPER 18V is primarily used to
remove linoleum, PVC, rubber, cork, design, and CV
coverings as well as needle-punched fl oor cover-
ing and carpeted fl ooring.
► Needle-punched fl oor covering, carpet, PVC.....
The coverings to be removed should be pre-cut in
blade-widths (Pic. B) and then removed with the
stripper in one step. In many cases, the glue can
also be removed at the same time.
► Coverings without a foam backing:
Prior to performing the stripping work, pre-cut the
strips in blade-widths (Pic. B). Regularly check
whether the blade is still straight and sharp.
► Coverings with a foam backing:
Only use sharp blades! Remove the large Sections of
the wearing surface. Use a carpet pulling claw for this.
Then remove the foam residue with the stripper. If
there is some foam in the recess, approach from the
side.
Wolff GmbH & Co KG | D-74360 Ilsfeld | Ungerhalde 1 | Fon: +49 (0)7062-91556-0 | Fax: +49 (0)7062-91556-41 | www.wolff -tools.de
18
► Coverings with a fl eece backing:
Do not remove the wearing surface beforehand. Cut
the covering into strips and strip them together with the
fl eece backing.
Warning
Important blade recommendation:
In general, no statements can be made on which
blades can be used for which blades, because the
variety of coverings and surfaces are too diverse.
These recommendations are to provide assistance!
► We recommend using fl at blades of varying lengths
and widths for fl exible, elastic fl oor coverings. The
harder the covering, the thicker the blade should be.
► The blade is generally inserted with the blade edge
up, unless it works itself too deep in the surface. In
this case, the blade must be inserted with the blade
edge down.