WOLFF AKKU JUNIO-STRIPPER 18V-230 V SET Traduction Du Mode D'emploi Original page 16

EN
Warning
Wear hearing protection!
Overall vibration values
(vector sum of three directions)
determined in accordance with EN 60745:
Vibration emission level .....................ah =
Margin of error .....................................K =
3.0 Preparing the machine
The AKKU JUNIO-STRIPPER 18V is maintenance-free.
3.1 Changing the blade (Pic. E)
Very sharp blade! You may cause injury without using the
blade protection!
Warning Disconnect the power supply before
changing the blade. Use work gloves for
your own safety.
► put on the blade protection (enclosed in the tools set)
► clean and loosen the screws of the blade mounting,
► set the wrench at a position opposite to the blade to
avoid injury. Replace the blade.
Make sure that the blade fi ts in exactly into the support. On
normal and hard subfl oors the bevel of the blade should
show upwards (Pic.C, 1), on soft subfl oors (e.g. chipbo-
ards) the bevel should show downwards (Pic.C, 2).
4.0 Use
4.1 Assembly
For your safety the JUNIO-STRIPPER comes with the
blade not mounted. It is fi tted directly at the buttom of the
striker
4.2 Switch-on/off
► Switch on picture D
Short time operation without engagement
Push the switch rocker forward (1 )and hold it.
Release the switch rocker to switch off .
► Switching on Figure D
Continuous operation with engagement
Push the switch rocker forward (1.)
and engage by pressing the front end (2.).
Wolff GmbH & Co KG | D-74360 Ilsfeld | Ungerhalde 1 | Fon: +49 (0)7062-91556-0 | Fax: +49 (0)7062-91556-41 | www.wolff -tools.de
16
► Switch off Figure D
To switch off the rocker switch ( 3 ) by
Release the pressure on the rear end.
The AKKU JUNIO-STRIPPER 18V is designed to remove
8,8 m/s²
foam adhesive or fl ooring residues. Also for the removal
+/- 1.5 m/s²
of fl oor coverings on stairs and in unaccessable areas, as
well as for removal of glass fi bre wall lining.
4.4 Working advice
WARNING!
NOTE
The batteries are not fully charged on delivery.
Charge the batteries fully before using them for the fi rst
time. See the operating instructions for the charger.
4.5 Inserting / changing the battery Fig. F + G
► The battery is fully charged Press it into the power tool
► To remove the release buttons press (1.) and pull out
the battery (2.).
ATTENTION!
The contacts of the battery when not in use
protect. Loose metal parts can short-circuit the contacts,
there is a risk of explosion and fi re!
4.6 State of charge of the battery Figure H
► By pressing the button, the charge status can be che-
cked on the LED of the battery status display.
► The display goes out after 5 seconds.
If one of the LEDs fl ashes, the battery must be chaged.
If no LED lights up after pressing the button, the battery
is defective and must be replaced.
4.7 Use of batteries
► Only use original batteries with the ones specifi ed on
the rating plate of your power tool Tension. When using
other batteries, e.g. Imitations, refurbished batteries
or third-party products, there is a risk of injury as well
Property damage from exploding batteries.