KREA Swiss oilSPRAY Mode D'emploi page 5

Spraying other materials?
The sprayer is only designed to spray oils of around 18 to 36 DIN/sec. Spraying other
materials is likely to produce a different effect. A simple way to reduce the viscosity of
food materials is to heat gently via a microwave or water unit, e.g. heating 550 ml of
thick butter fat with a viscosity of circa 65 DIN for 20 seconds in a standard microwave
can reduce the viscosity to circa 30 DIN/sec without significantly impacting it`s
usability.
CLEANING
IMPORTANT: Always remove the electrics and heating unit before washing the
gun. These parts should never be exposed to liquids.
Always clean immediately after use. For external cleaning, simply wipe down the
outside of the sprayer with an approved food grade detergent. For internal cleaning,
if using materials other than light oil, we recommend to spray through half a container
of food safe mild detergent solution and then clean the individual parts. Alternatively,
the plastic components can be placed in the regular 60°C / 140°F dishwasher cycle.
Careful use of a soft pipe cleaning brush is also recommended but care should be
taken not to damage the cylinder by using abrasive or sharp tools. If available,
passing air flow through the nozzle and suction tube can ease the cleaning process.
The sprayer is designed with quality components. If you experience any issue, we
recommend first following the trouble shooting document and films on our
website: www.KreaSwiss.com/professional-food-sprayer-guns. In most cases
a part has been forgotten during post cleaning assembly. If your issue persists please
contact your reseller for additional support, including the article number (Page 2) in
any correspondence.
DISMANTLING AND ASSEMBLING (see page 2)
• Remove the round nozzle (9) and then unscrew the nozzle extension screw (8)
from the pump housing (5).
• Remove the 3 piece "atomiser unit" (7) from inside the chamber. The metal
adapter (6) should never be removed. Place all parts in a small dish and clean
them following the cleaning steps outlined earlier. The suction tube (10) and
container (11) can be washed in the sink.
• Remove the service screw (2) and take off the pump housing (5). Put the
piston (3), piston spring (4), hood (1) to one side and wipe them down as
outlined above.
• To assemble the gun, do so in reverse order. The piston should move freely in the
pump housing. Ensure the service screw, nozzle extension and round nozzle
pieces are all screwed on tightly.
5