Status Leds - Abus TVAC25100 Manuel Utilisateur

5.2 Status LEDs

These status LEDs on the network connection indicate the current connection status of the network
components.
These status LEDs indicate the current connection status of the two devices.
Description LED on
PW Switched on
CPE / CO CPE (Master)
LINK Connected
If the LED "Link" flashes rapidly, the devices are attempting to set up a connection to each other. If they
flash slowly, no connection has been set up.
Warning:
Please make sure that the receiver side (router, PC, etc.) is always set as the control
unit (Master) (DIP switch 1 = ON).
Status LED Bandwidth speed
ON Half-duplex 100 MB/s
OFF Full-duplex 100 MB/s
ON Open circuit
OFF No connection
Flashing Data transmission
LED flashing
-
-
Connection setup
20
English
LED off
Switched off
CO (Slave)
-