Description Of The Dip Switches And Status Leds; Dip Switches - Abus TVAC25100 Manuel Utilisateur

5. Description of the DIP switches and status LEDs

5.1 DIP switches

Number Function
1 Master (CPE) / Slave (CO)
2 Transmission
3 Transmission rate
4 Signal-to-noise-ratio
DIP 1: Master / Slave
ON position
OFF position
DIP 2: Transmission
ON position
OFF position
DIP 3: Transmission rate
ON position
OFF position
DIP 4: Signal-to-noise-ratio (SNR)
ON position
OFF position
Use this switch position to connect the device to a PC or a
Control device
router which accesses the network camera on the slave side.
Select this switch position to use the device on the network
End device
camera.
Use this setting to establish a fast data connection. Please
Fast mode
observe that data loss could occur using this setting.
Use this setting if there is a high data rate, and thereby avoid
Interleave mode
any data loss on the transmission range.
Use this setting to utilise a maximum data connection with a
Unlimited
transmission rate of up to 100 MB/s download/60 MB/s upload.
Use this setting in the event that data losses occur on the
transmission line. The transmission rate is then decreased to
Limited
50 MB/s download / 30 MB/s upload in order to reduce the
data loss.
Standard noise reduction which is used to compensate
6 dB
interference on the line.
Increased noise reduction; the signal-to-noise ratio is
increased in this mode. This will be necessary in the event that
9 dB
increased data loss occurs on the wiring section. The
maximum transmission path is then reduced in this mode.
ON position
Control unit (Master)
Fast mode
Unlimited
6 dB
19
English
OFF position
End device (Slave)
Interleave mode
Limited
9 dB