Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
En ENGLISH
10. Accessories
Use only genuine Walter accessories. See page 5.
Use only accessories which fulfill the requirements and specifications listed in these operating instructions.
A Cutting guard clip / guard for cut-off grinding
Designed for work with cutting disc and diamond cutting discs. Once the cutting guard clip is fitted, the safety
guard becomes a cutting guard.
B Dust filter
The fine mesh filter prevents coarse particles from entering the motor housing. Remove regularly and clean.
C Multiple position bar for side handle
Permits numerous handle positions.
For a complete range of accessories, see
11. Repairs
Repairs to electrical tools must be carried out by qualified electricians ONLY! If the connection lead is
damaged, it must be replaced by a special connection lead. Contact your local Walter representative
if you have Walter power tools requiring repairs. For addresses see
You can download a list of spare parts from www.walter.com.
12. Environmental Protection
The generated grinding dust may contain harmful substances. Dispose appropriately.
Observe national regulations on environmentally compatible disposal and on the recycling of disused
machines, packaging and accessories.
13. Technical Specifications
Explanatory notes on the specifications on page 4. Changes due to technological progress reserved.
Ø
= max. diameter of the accessory
t
= max. permitted thickness of the clamping shank on accessory when using 2-hole nut (13)
max,1
= max. permitted thickness of clamping shank on accessory when using "Quick-R" clamping nut
t
max,2
t
= roughing disc/cutting disc:
max,3
max. permitted thickness of accessory
M
= spindle thread
l
= length of the grinding spindle
n*
= no-load speed (maximum speed)
n
*
= no-load speed (adjustable)
V
P
= rated input power
1
P
= power output
2
I
= Current at 120 V
120 V
m
= weight without mains cable
* Machines with the designation DYNAMAX or DIALSPEED : Energy-rich, high-frequency interference can
cause fluctuations in speed. The fluctuations disappear, however, as soon as the interference fades away.
The technical specifications quoted are subject to tolerances (in compliance with the relevant valid standards).
Emission values
These values make it possible to assess the emissions from the power tool and to compare
different power tools. Depending on the operating conditions, the condition of the power tool or the
accessories, the actual load may be higher or lower.
www.walter.com
or the accessories catalogue.
www.walter.com.
15
Publicité
Table des Matières
