Walter QS Finisher Mode D'emploi page 13

En ENGLISH
Note: We recommend using our angle polisher for polishing work.
7.2 Switching On and Off
Always guide the machine with both hands.
Switch on first, and then guide the accessory towards the workpiece.
Avoid inadvertent starts: always switch the tool off when the plug is removed from the mains socket or if
there has been a power cut.
In continuous operation, the machine continues running if it is forced out of your hands. Therefore,
always hold the machine with both hands using the handles provided, stand securely and concentrate.
Avoid the machine swirling up or taking in dust and chips. After switching off the machine, only place it
down when the motor has come to a standstill.
Machines with slide switch:
Switching on: Push the sliding switch forward. (5) For continuous activation, now tilt downwards until it
engages.
Switching off: Press the rear end of the slide switch (5) and release it.
Machines with paddle switch (with non-locking function):
Switching on: Slide the switch-on lock (10) in the direction of the arrow and press the trigger (9).
Switching off: Release the trigger switch. (9)
Machines with the designation IRONMAN:
Torque activation (with dead man's switch)
Switching on: Slide the trigger switch (9) forwards and then push the trigger switch (9) upwards.
Switching off: Release the trigger switch (9).
Machines with the designation IRONMAN:
Continuous operation (depending on features)
Switching on: Switch the machine on as described above. Now slide the trigger switch (9) forwards again
and release in the front position to lock the trigger switch (9) (continuous operation).
Switching off: Push the trigger switch (9) upwards and release.
13