ROBBE Pilatus PC21 Nano-Racer Notice De Montage Et De Mise En Œuvre page 3

Fig. 1
- Glue the tailplane to the fuselage. Ensure that it is exactly
parallel to the wing (see Fig. 3).
Fig. 2
- Glue the fin to the fuselage. Ensure that it is exactly at
right-angles to the tailplane (see Fig. 3).
Fig. 4
- Attach the pushrod to the elevators in such a way that they
are horizontal. Check from the transmitter that the elevator
servo is at neutral.
Fig. 5
- Referring to the illustration, glue the horizontal strake to
the fin, keeping it exactly central. Note that the swept edge
faces the rear.
Fig. 6
- Glue the two dummy exhausts to both sides of the fuselage
(see also Fig. 7).
Fig. 8
- Position the airborne components such as the flight battery
(Article No.: 6603 or 6605) and receiver as shown in Fig.
8; this will ensure that the model balances at the stated
Centre of Gravity.
Fig. 9
- Glue the rear fuselage strake in the appropriate slot on the
underside of the fuselage.
Fig. 10
- The Centre of Gravity is located 48 mm aft of the leading
edge at the wing root.
Building and Operating Instructions - Pilatus PC21 Nano-Racer
11
Aileron
Elevator
Fig. 11 (control surface travels)
- The control surface travels are measured at the inboard
end of the control surface.
- The stated control travels are just a guide for the first few
flights. The final settings should be selected to suit the
individual pilot's flying style.
Expo settings
Elevator -40%; aileron -60%
- The Expo settings should also be adjusted to suit the pilot's
preference.
4 mm
4 mm
5 mm
5 mm
No. 2599
3