Save Preset Menu - Ecler ALMA26 Notice D'utilisation

6.2. SAVE PRESET MENU

Once you have edited the active preset or template, the procedure to save the current setup in a
user preset memory is the following one:

From the main menu, press SHIFT + SAVE

The SAVE PRESET message is displayed and a preset number is flashing
[ P 0 7 ] S T E R E O

Select the user preset using the rotary control, and then select one of the two following
options:

Press SHIFT + SAVE to validate the selection
Or

Press SHIFT + CANCEL to cancel the selection and display again the preset from the
selection list
Pressing SHIFT + EXIT at any point during the above process cancels the selection and brings
the main screen back.
If the selection is validated (SHIFT + SAVE) the following screen is displayed, allowing you to
rename the destination preset:
[ P 0 7 ] S T E R E O
To rename the preset:

Press the right PARAM key to select the first character to edit

Edit the new character with the rotary control

Press the left or right PARAM key to select another character to edit

Edit the new character with the rotary control

Etc...

Pressing SHIFT + CANCEL cancels all previous changes, displays the original name and
maintains the edit mode in order to be able to rename the preset again

Once all the desired characters are edited, confirm the changes by pressing SHIFT +
SAVE, displaying the PRESET SAVED message for a few seconds. The preset is stored
in memory, but is not selected as active preset just by the fact of having been saved

The main screen returns, showing again the current preset at the time, and it is not
necessarily the newly saved preset
Pressing SHIFT + EXIT at any point during the above process cancels the selection and brings
the main screen back.
The parameters stored in a preset are:

All the input and output settings, including their names (labels)

The A and B REMOTE ports setup

The internal signal generator setup
S A V E P R E S E T
R E N A M E P R E S E T
L I V E 3 W
L I V E 3 W
11