Rear - Sony RVP-411DS Mode D'emploi

Rear

4 TERMINATE switch
Sets to ON when the REMOTE IN connector is
connected to the RS-422 interface and nothing is
connected to the REMOTE OUT connector.
5 REMOTE IN/OUT connectors (D-sub 9-pin)
Connect the RS-422 interface for interactive
communication with the external equipment.
6 INDEX NO. switches
When two or more projectors are connected, set the
index number of each projector.
7 CONTROL S IN/OUT jacks (minijack)
Connect to the CONTROL S jacks of other Sony
equipment. It is then possible to control the whole
system with a single remote control unit.
8 STANDBY indicator
When MAIN POWER is on, the red indicator lights up
indicating the unit is in standby mode. When the red
indicator is lit, the projector can be turned on/off with
the remote control unit (not supplied).
!¡
9 POWER indicator
Green indicator lights up when the power is turned on.
0 Error code indicator
When an operational error occurs, the error code is
indicated. "00" indicates no error.
!¡ Optional video input board attachment part
Optional video input board can be attached.
!™ 31K RGB IN connectors (BNC connector)
Connect to the 31K RGB output connectors.
!£ ABL LINK IN/OUT jacks (minijack)
Connect to the ABL LINK jacks on other projectors to
activate the linked ABL function.
!¢ MAIN POWER switch
!∞ AC IN socket
Connect the supplied power cord.
4 6 7 8 9 0
5
INDEX
TERMINATE REMOTE CONTROL-S
OFF ON IN OUT IN OUT
31K RGB IN
ABL LINK
R G/G SYNC B SYNC/HD VD
IN OUT
!™ !£
POWER
STANDBY POWER
INDICATOR
AC IN
MAIN
ON/ OFF
!¢ !∞
7 (E)