Preparing The Tool; Loading Fasteners; Using The Tool - Rona RRN-COIL/11G-001 Guide De L'utilisateur

OPERATING PROCEDURES

PREPARING THE TOOL

1. After reading and understanding this entire manual, connect tool to air
2. Turn on the air compressor and adjust the regulator to the proper pressure
CAUTION:
= Keep the tool pointed away from yourself and others at all times.
= Always connect the tool to air supply before loading fasteners.
= Do not load fasteners with safety or trigger depressed.
!
= Always wear approved safety glasses and hearing protection when preparing
= Never use a tool that leaks air or needs repair.

LOADING FASTENERS

1. Press down latch, open feeder cover and magazine cover
2. Adjust nail support to suit desired nail length. The nail support can be lifted
3. Remove retainer from a coil of nails, uncoil approximately 3 nails, and
4. Close the magazine cover. Close and latch the feeder cover.
5. Adjust the directional exhaust deflector so that the exhaust air will be
6. Adjust the shingle guide by loosening the retaining screw and sliding the

USING THE TOOL

Complete all the steps in Preparing the Tool and Loading Fasteners, above,
before using the tool.
This tool can be fired two different ways:
1. Position the nose of the tool onto the work surface, push forward on the tool
2. Squeeze and hold the trigger while pushing the nose of the tool against the
CAUTION:
= Remove finger from the trigger when not driving fasteners.
= Never carry tool with finger on trigger: tool will fire a fastener if the safety is
= Keep tool pointed in a safe direction at all times.
= Never attempt to drive nails into materials too hard to penetrate, or at too
!
= Disconnect tool from air supply before doing any disassembly, maintenance,
= Clean and inspect the tool daily. Carefully check for proper operation of
supply.
for the fastener size you are using. (See the Using the Tool section below
with regard to adjusting this.)
or operating this tool.
and rotated to three different positions that provide support for different
length roofing nails. The lowest position is for 1-3/4" (45 mm) nails, the center
position is for 1-1/4" (32 mm) and 1-1/2" (38 mm) nails, and the upper
position for 7/8" (22 mm) and 1" (25 mm) nails.
position the coil on the nail support with the second nail in the feed fingers.
directed away from the operator. Grasp the deflector and rotate it to the
desired position.
shingle guide to the desired position. Tighten the retaining screw firmly. (The
shingle guide can be used as an aid in positioning the shingle to be nailed at
a specific distance from the front edge of the previous row of shingles.)
to depress the safety, and squeeze the trigger to fire a nail. This "trigger fire"
method provides the most accurate fastener placement.
work surface. The tool will fire a nail every time the safety is depressed. This
"bump fire" method allows very fast, repetitive fastener placement.
bumped.
steep an angle, or too near the edge of the workpiece. The fastener can
ricochet causing personal injury.
clearing a jammmed fastener, leaving the work area, moving the tool to
another location, or handing the tool to another person.
trigger and safety mechanism. Do not use the tool unless both the trigger
and the safety mechanism are functional, or if the tool is leaking air or needs
any other repair.
13
070710