Nicols PAR LED 1810 X IP Manuel D'utilisation page 9

NOTE:
The product can be mounted at any angle and in any position. It is possible to further adjust the angle of the product using
the two adjustment knobs located on the side of the fixture.
2.2 Special construction for DMX connection.
☆ At last fixture, the DMX cable has to be terminated with a terminator to reduce signal errors. Solder a 120-ohm 1/4W
resistor between pin 2(DMX-) and pin 3(DMX+) into a 3-pin XLR-plug and plug it in the DMX-output of the last fixture.
☆ If the controller is 5-pin output, it's necessary to use an adaptor to transfer signal from 5-pin output to 3-pin XLR-plug or
you can connect cables as following:
PART 3 Display Panel Operation
3.1 Disp la y panel menu instruction
]
[MODE menu selection or return to previous menu.
[UP] press [UP] through the menu list to increase/change the value of the current function.
[DOWN] press [DOWN] through the menu list to decrease/change the value of the current function.
[ENTER] confirm & quit out current function setting.
3.2 Displa y M enu instruction (genera l)
No Show Function
1 d001 DMX address
2 A001 DMX address
r255
3 Red dim
4 G255 Green dim
5 b255 Blue dim
u255
6 White dim
F000
7 Strobe
8 CC15 Colors Jump
DE15
9 Colors Gradate
CP15 Colors Pulse
10
11 Soud Sound-Active
3.3 DMX Channel instruction
4-Channel Mode
Value Instruction
4CH mode,UP,DOWN increase
001~512
or reduce the value,
8CH mode UP, DOWN
001~512
increase or reduce the value
000~255 UP, DOWN Change brightness
000~255 UP,DOWN Change brightness
000~255 UP,DOWN Change brightness
000~255 UP,DOWN Change brightness
UP,DOWN change the speed
000~255
01 ~ 15 UP,DOWN change the speed
01 ~ 15 UP,DOWN change the speed
01 ~ 15 UP,DOWN change the speed
SURE
8