Dismantling The Tool; Head Assembly - Avdel Genesis G1 Manuel D'instructions

S e r v i c i n g t h e To o l
D i s m a n t l i n g t h e To o l
Before dismantling the tool the oil must be emptied from it.
•
With the air supply switched OFF at ON/OFF Valve Assembly 53 remove Bleed Screw 1 and Bonded Seal 5.
•
Insert tool over a suitable container, switch air supply ON and actuate tool.
•
Oil will expel from bleed screw orifice into container.
•
Switch air supply OFF after all oil is expelled.
Ensure the bleed screw orifice is facing away from the person performing this operation.
H e a d A s s e m b l y
•
Twist and pull off Stem Collector Bottle Assembly 24. See illustration on page 7.
•
Remove Stop Plate Assembly 69 by unscrewing Screws 63 2 off.
•
Unscrew Retaining Nut 47.
•
Pull off Bottle Adaptor Assembly 31 together with 'O' Rings 19 and 27.
•
Remove End Cap Assembly 34 together with 'O' Rings 65 and Lip Seal 8.
•
Remove Spring 64.
•
Loosen Locknut 39 with a spanner* and unscrew Male 'T' Adaptor 40 together with 'O' Ring 11.
•
Withdraw Vacuum Sleeve 41.
•
Remove Locknut 39 together with 'O' Rings 18 and 14.
•
Push Head Piston 35 to the rear and out of Head Assembly 50 taking care not to damage the cylinder bore.
•
Using circlip pliers* remove Seal Retainer 42. Push Lip Seal 7 and Bearing Tape 25 to the rear and out of Head Assembly 50 taking
care not to damage the cylinder bore.
•
Remove Seal Housing 48 and Lip Seal 2.
Assemble in reverse order noting the following points:
•
Place Lip Seal 7 onto the insertion rod* ensuring correct orientation. Locate the guide tube* into the head of the tool and push the
insertion rod* with the seal in place through the guide tube*. Pull the insertion rod* out and then the guide tube*.
•
The chamfered edge of Seal Retainer 42 must face forward with the gap at the bottom.
•
After fitting Lip Seals 10, 9, 'O' Ring 17 and Bearing Tape 26 onto the Head Piston 35 ensuring correct orientation, lubricate the
cylinder bore and place the piston sleeve* into the back of Head Assembly 50. Slide the bullet* onto the threaded part of Head Piston
35 and push the piston with the seals through the piston sleeve* as far as it will go. Slide the bullet* off the piston and remove piston
sleeve*.
•
Male 'T' Adaptor 40 must be fully tightened onto Head Piston 35 before tightening Locknut 39 against it.
•
Reprime in accordance with the instructions on page 29.
* Item included in the Service Kit. For complete list see page 20.
Item numbers in bold refer to the general assembly drawing and parts list on pages 26 and 27.
21