Rules For Installation; Fire Safety - Nordica STEFANY Forno Notice D'utilisation

Below the hearth grate there is an extractable ash drawer with
relevant closing door.
The heating of the environment is made:
a) by convection (about 70%): the passage of air through the double sheath of the stove releases heat in the
environment
b) by radiation (about 30%): through the panoramic glass and the external hot surfaces of the stove, the heat is
radiated into the environment.
The chimney stove is equipped with controls of primary (Picture 5 pos. A) and secondary air (Picture 5 pos. B), by
which it is adjusted the combustion air.
PRIMARY AIR CONTROL (lateral right)
(Picture 5, pos. A) The primary air control is found below the hearth door, in
the style of a pull-push lever. By this control it is adjusted the passage of air
coming from the lower part of the stove and through particular channels flows
in the fuel direction. The primary air is necessary for the combustion process.
The ash drawer must be regularly emptied, so that the ash does not obstruct
the primary air entry. During wood combustion, the primary air control must
be opened only for a while, because otherwise the wood burns fast and the
stove may overheat. The control is open when the bar is pulled out (see
chapter 10)
SECONDARY AIR CONTROL (lateral left)
(Picture 5, pos. B) To the left of the hearth door there is the secondary air
register. This must be opened (then completely inserted), especially for wood
combustion, so that the carbon not yet burned will be subjected to a post-
combustion.. (see paragraph 10).
3.

RULES FOR INSTALLATION

The stove, assembled and ready for the installation, must be connected with a junction to the existing flue of the
house. The junction must be possibly short, straight, horizontal or positioned a little uphill. The connections must be
tight.
It is obligatory to respect the National and European rules, local regulations concerning building matter and
also fireproofs rules. Please apply to your chimney sweeper for all information.
You should verify the sufficient air entrance for the combustion in the installation place, with particular attention to
windows and doors with tight closing (seal ropes).
It is not allowed the connection of various appliances to the same chimney. The diameter of the opening for the
connection must correspond at least to the diameter of the smokes pipe. The opening should be equipped with a wall
connection for the reception of the exhaust pipe and a rose window.
Before installation, verify if your floor can support the weight of the stove (for ex. distributing weight plate).
LA NORDICA is not responsible in case of modification of the product and for the use of not original spare
parts.
THE HEARTHS MUST NOT BE MODIFIED.
4.

FIRE SAFETY

In the installation of the stove the following safety measures are to be followed: (See Picture 6)
a) In order to ensure sufficient thermal insulation, respect the minimum safety distance from objects or furnishing
components flammable and sensitive to heat (furniture, wood sheathings, fabrics. etc.) and from materials with
flammable structure (see Picture 6 - A). All the minimum safety distances are shown on the product data
plate and lower values must not be used.
b) In front of the chimney stove there must not be any flammable object or building material, sensitive to heat, at less
than 100 cm's. of distance. This distance can be reduced to 40 cm's if you will install in front of the element to
protect a retro ventilated and heat resistant protection.
c) If the product is installed on a non totally refractory floor, one must foresee a fireproof background. The floors
made of inflammable material, such as moquette, parquet or cork etc., must be replaced by a layer of no-
inflammable material, for instance ceramic, stone, glass or steel etc. (dimensions according to the local
regulations). The platform must stick out 50 cm's in front and 30 cm's sideways (Picture 6 B).
d) no flammable components (e.g. wall units) must be present above the product.
The stove must work exclusively with inserted ash drawer.
Solid combustion residuals (ashes) must be collected in an air-tight and fire-resistant container. The device must
never be switched on when there are gaseous emissions or vapors (for example glue for linoleum, gasoline etc.). Do
not deposit flammable materials close to the stove.
20
STEFANY Forno / SVEZIA New / NORVEGIA New
B
A
Picture 5
7193400 – EN