Publicité
Les langues disponibles
Les langues disponibles
Operating instructions AxisDrive IPS / IPS RF
Dear customer,
Congratulations on choosing a high-quality product from Hettich Franke GmbH & Co. KG.
Before attempting to install and put the product into operation, read these instructions
carefully and make yourself familiar with its operation.
Function: Gradual adjustment of head and foot sections, either individually or
simultaneously.
Installation instructions: AxisDrive is delivered ready for installation. If the motors are
not in the installation position, connect the mains plug and push the buttons
of the handset (Fig. 5). The motors move into the installation position.
For safety reasons isolate from the mains power supply by disconnecting the motor
plug.
Assembly: For easier assembly, turn over the slatted bed frame so that the motor action
faces upwards (Fig. 4). Push the AxisDrive firmly onto the motor hooks until the tubes
latch into the U-shaped motor openings. Observe that the head symbol at the drive points
towards the head-end of the slatted bed frame. For fastening the AxisDrive to the motor
action, push the sliding covers over the lid openings. Observe that the sliding covers (Fig.
2) are pushed into the provided guide grooves centred.
Place the slatted bed frame in the bed.
Commissioning of the IPS with handset cable:
•
Plug handset cable into the socket (Fig. 2)
•
Secure cable against accidental disconnection by means of the stress relief
(Fig. 2)
•
Connect mains plug into mains outlet
•
Your motor-adjustable bed is now ready for use
Commissioning of the IPS RF with handset RF (radio frequency):
Option 1:
•
The two 9V block batteries for emergency lowering must not be connected
•
Put the batteries into the battery compartment of the handset RF (Fig. 6).
Ensure proper polarity.
•
Connect mains plug into mains outlet
•
The drive is now in "learn mode" for approx. 30 seconds
8
•
•
•
Option 2:
•
•
and
•
•
If encoding fails, wait for approx. 2 minutes and then repeat commissioning.
After a current interruption or power failure there is no need to encode the AxisDrive
again. It maintains the previous encoding.
Emergency lowering capability: The AxisDrive has an emergency lowering capability.
Thanks to the integrated 9V block battery it is possible to move to the lying position in
case of power outage. Connect the battery according to Fig. 1 or Fig. 3 (AxisDrive with
handset RF requires 2 batteries). If you loose the handset RF or in case of a power
failure, AxisDrive can be returned to the lying position by means of the coding button
(fig. 3).
Attention! When the coding button is pushed briefly, the slatted bed frame will
move to the lying position automatically.
Note: If you have two or more systems, take them into operation in sequence rather
than at the same time.
Have a refreshing and relaxed sleep with our high-quality product.
Troubleshooting
AxisDrive cannot be adjusted although the handset is operated.
a. Check mains connection
b. Check handset plug
c. For handset RF: repeat encoding
9
Push the button for lowering the head and foot section on the handset RF
during the learn mode (Fig. 5, button
)
Successful encoding is confirmed by an acoustic signal
Your motor-adjustable bed is now ready
Check that the batteries are inserted in the handset RF battery
compartment and that the mains plug is connected to the mains outlet
Push and hold the button for lowering the head and foot rests on the
handset RF (Fig. 5, button
) and push the coding button on the AxisDrive
at the same time (Fig. 3)
Successful encoding is confirmed by an acoustic signal
Your motor-adjustable bed is now ready for use
Publicité
