Maintenance - Haussmann Xpert DP1200 Manuel De L'utilisateur

WARNING
• Remember to remove chuck key before operating the
machine.
A laser light is radiated. Avoid direct eye contact. Always
turn off the laser when the laser is not in use.
• Keep children away from laser device. Misuse of laser
can result in irrepairable eye injuries.
• Do not do any adjustment to increase the laser power.
• Do not point the laser beam towards people and /or
reflecting surfaces.
• Do not look directly into the laser beam.
• Never open the laser housing for repair or adjustment.
• Laser warning label: Max output <5mW DIODE
LASER:630-660nm, Complies with 21CFR 1040.10 and
1040.11.
ADJUST DRILL DEPTH
Refer to Figure 17
Two ways to adjust the drill depth to the desired height:
• Loosen the lock knob.
• Rotate depth gauge to the desired setting.
• Retighten the lock knob securely.
The other way to adjust the drill depth to the desired
height:
• Turn the switch to "OFF" position.
• Secure the workpiece to the drill table by using a scrap
piece of wood between the workpiece and clamp to
avoid damage to workpiece.
• Lower the drill bit by turning the feed handles until the
drill bit touches the workpiece.
Note: This sets the depth to zero at the surface of the
workpiece.
WARNING
Turn the switch to "OFF" position and disconnect the
machine from power source before servicing or disassem-
bling any components.
CLEANING
• Keep machine and workplace clean. Avoid
accumulation of sawdust on the tool.
• Be certain motor is kept clean and free of dust.
• Use soap and water to clean painted parts, rubber parts
and plastic guards.
• Remove the workpiece and increase the depth of the
drill bit (past zero) until the desired depth is reached on
the dial.
• Hold in this position and lock the depth using the Dial
lock knob to limit the drilling depth.
• Using a clamping device and reposition the workpiece to
the table.
• Turn on the tool and drill to the desired depth.
Figure 17

MAINTENANCE

LUBRICATION
• A light coat of paste wax on the work table to prevent
rust.
TOOL REPAIRS
• If power cord is worn, cut or damaged in any way, do
not operate the machine.
• Replace any worn, damaged, or missing parts. Use
parts listed to order parts.
• Any attempt to repair motor may create a hazard unless
repair is done by a qualified service technician.
• Call the customer line at 1-866-206-0888.
23
Depth
Gauge
Lock Knob