Installation Of The Appliance - Wolkenstein WMW 720 B Mode D'emploi

3
Rotation axis
4
Rotation ring
5
Turntable
6
Control panel
7
Wave guide

2.2 Installation of the appliance

1. remove all packaging materials. If a safety film is on the appliance, pull it off
carefully. Check that the appliance is not damaged. If you detect any damage,
please contact the shop you purchased the appliance at.
2. Install the appliance in a dry and corrosion-safe place. Keep the appliance away
from sources of heat and moisture such as gas burners, water containers etc.
3. Strictly observe the minimum distances for proper ventilation on the schedule
below:
Back of the appliance ↔ Wall
Sides of the appliance ↔ Wall, cupboard etc.
Free space above the appliance
4. The distance to the ground should be min. 85 cm.
5. Install the appliance more than 5 m away from TV-sets, radios and antennas to
avoid interferences.
6. The plug must always be accessible after installation. Only use a proper grounded
safety socket for connection.
7. Operate the appliance with its door closed only.
8. Manufacturing residues or oil having remained in the oven cavity or on the
heating element may cause some odours and smoke emission. These are normal
operational parameters, which will disappear after a number of uses. Open the
The turntable is placed on the rotation axis. The
motor installed below enables the rotational
movement.
The turntable is also placed on the rotation ring,
which stabilises the turntable and maintenances its
balance.
Place the food on the turntable. The rotation
ensures uniform cooking.
See chapter 3,
OPERATION
The wave guide is installed on the right side inside
the oven cavity.
.
min. 10 cm
min. 5 cm
min. 20 cm
32