Intex 28290 Manuel Du Propriétaire page 9

POOL SETUP (continued)
3. Vertical legs assembly
• For 8' x 20" (244 cm x 51 cm):
Attach the leg's end cap (4) to the bottom of each leg (7) first.
With the beams and T-joints assembly resting on the ground,
insert the top of the leg into the bottom of the T-joint (3) (see
drawing 3.1). Continue the process with all the vertical legs.
NOTE: This pool size does not come with an all-around center
belt.
• Lift the beams assembly and make sure all the legs are in
a vertical position (see drawing 3.2). Push all the T-joints
downward to ensure they are firmly connected to the legs.
• For 10' (305 cm) and above sizes:
Attach the leg's end cap (4) to the bottom of each leg (7) first.
With the beams and T-joints assembly resting on the ground,
slide one vertical leg into the belt loop located in the middle
of the pool liner and insert the top of the leg into the bottom
of the T-joint (3) (see drawing 3.3). Continue the process
with all the vertical legs.
• Lift the beams assembly and make sure all the legs are in
a vertical position (see drawing 3.4). Push all the T-joints
downward to ensure they are firmly connected to the legs.
• Pull gently, in an outward direction, the bottom of the leg making sure the leg is vertical and perpendicular
to the level ground.
4. Filling of the pool
• The following applies to pool liners with hose connectors (16' (488cm) & below pools). If the pool was
purchased without a filter pump, insert two of the three plugs (10) into the black filter pump outlets. Do
this from the inside of the pool so that water will not run out when filling it. If the pool was purchased
with a filter pump, read the Krystal Clear™ Filter Pump Manual first and then proceed to next installation
step.
• Before filling the pool with water, ensure that the drain plug inside the pool is closed and that the drain
cap on the outside is screwed on tightly. Fill the pool with no more than 1 inch (2.5 cm) of water. Check
to see whether the water is level.
IMPORTANT: If the water in the pool flows to one side, the pool is not completely level. Setting
up the pool on unlevel ground will cause the pool to tilt resulting in the sidewall material bulging
and a potential collapse of the pool. If the pool is not completely level, you must drain the pool,
level the area or move the pool to a different area that is level, and re-fill the pool, following the
above directions.
• Smooth out the bottom liner wrinkles (from inside the pool) by pushing out where the pool floor and pool
sides meet. Or, (from outside pool) reach under the side of the pool, grasp the pool floor and pull in an
outward direction. If the ground cloth is causing the wrinkles, have 2 people pull from opposite sides to
remove all wrinkles. Use the properly assembled pool ladder when entering or exiting the pool during this
process. Also make sure all the legs are vertical and perpendicular to the ground.
• Fill the pool with water up to just below the sleeve line
(see drawing 4).
SAVE THESE INSTRUCTIONS
(87IO) METAL FRAME POOL ENGLISH 7.5" X 10.3" PANTONE 295U 04/29/2023
7
4
7
4
WATER LEVEL
87
English
A
3.1 3.2
3
7
4
3.3 3.4
3
7
4
4
Page 9