Slackline-Tools SLACKTIVITY Mode D'emploi page 24

V. INSTALLATION PULLING AID**
The Slackline-Tools pulling aid has to be installed at the
end of the remaining line which runs out of the pulley
24
system prior tightening.
• Pick up the remaining line and run it through the ring
of the pulling aid (Fig. 14, 1).
• Continue as shown in Fig. 14, 2–4.
• Now tighten the Slackline by using the sewn handloops
when pulling away from the Slackline.
** included in the 35/45 m SlackTivity Kits; for all others available optionally.
1
2
3
4
Fig. 14