Handle Assembly; Suction Head Assembly - NetSpa Super Vac Guide D'utilisation

2. Setup

3. Handle assembly

Insert the handle into the cleaner as shown until the
side pins on the handle are enclosed in the handle
locking holes.
To release the handle, press down simultaneously the two side pins and pull out the handle.
4. Telescopic pole assembly
Insert the end of the telescopic pole into the cleaner
as shown until the side pins are enclosed in the
pole locking holes.
To release the telescopic pole, press down simultaneously the two side pins and pull out the
pole.

5. Suction head assembly

Insert the suction head directly to the suction hole of
the cleaner tightly.
The use of the suction head is recommended
to vacuum small pebbles and leaves (fig. A). For
stones and others larger garbage, the suction head
should be removed (fig. B).
Brushes on the suction head can be removed by pulling out directly from the head.
For vinyl, liner and fiberglass pools, it is recommended to keep the brushes on the suction
head to prevent damage to your pool.
16
To assemble parts 2 & 3, you need to
align the arrows of each part, insert the
part 2 into 3 then rotate from open to
close position.