Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
GETTING STARTED
1. Charger use
A
As illustrate on picture A, unplugged the charger knob. Note: There is a elastic thread
1.
which connecting the knob and body, DO NOT long-distance pulling or pull at the knob,
so as not to cause the thread snapped.
2.
Insert the plug of one end of charger, the indicator turns green.
3.
Insert the plug of another end of charger in the automatic cleaner,the indicator turns red.
4.
Charge time is around 3 hours, and the indicator turns green when charging finished.
5.
Plug out the charger from the automatic cleaner, then unplug the charger from the power.
6.
Charger knob and the body have to be tighten up again,until it as picture B shown, to
make sure it won't be leakage. Note: The rope need to be suck into the knob of charger
by finger while tighten it up.
7.
Now you can use the cleaner according to the instruction normally.
WARNING!
Charging must be done in indoors, in a well ventilated area away from the sunlight, children,
heat and ignition sources.
Never use the charger if any damage is found.
Use the original the charger provided only.
Make sure cleaner and the charger are clean and dry before set up.
CAUTION! Put the charging cover after charging. Placing cleaner in water without putting
the charging cover will void your warranty.
NOTE: Charge the cleaner 3 hours prior to the first use. Normally cleaner can be operated
45 to 60 minutes after fully charged.
B
C
15
Publicité
Table des Matières
