Daikin BRC52B61 Mode D'emploi page 9

1. Transmission source
• The source where the signal will be transmitted.
2. Signal transmission indication
• Blink to confirm that the last setting has been transmitted to the unit.
3. "ON/OFF" Button
• Press once to start the air conditioner unit.
• Press again to stop the unit.
4. Fan speed selection
• Pressing the
order:
• Stop pressing when the desired fan speed appears on the display screen.
5. Operation mode
• Press the MODE button to select the type of operating mode.
• For cooling only unit, the available modes are: COOL ( ), DRY ( ) and
FAN ( ).
• For heat pump unit, the available modes are: AUTO (
DRY ( ), FAN ( ) and HEAT (
• The AUTO (
4-pipe system.
6. Automatic air swing
• Press the SWING
• To distribute the air to a specific direction, press the SWING
until the louver move to the desired direction and press the button once again.
Swing mode selection method (model dependent)
• Press SWING ( ) button for 4 seconds to enter field setting mode. While in field
setting mode, it will only show SWING MODE (
• Press temperature
Swing Mode 1 to Swing Mode 3.
• There are 3 different SWING MODE, which are:
Swing mode 1
SWING MODE will not activate unless SWING is activated.
Swing is indicated by the logo:
• If no mode changes within 4 seconds, unit will operate according to the selected
SWING MODE (
OPERATING GUIDE
button continuously will toggle the fan speed in the following
Low Med
) mode is unavailable for chilled water system except
button to activate the automatic air swing function.
and button to select SWING MODE (
Swing mode 2 Swing mode 3
).
High Auto
).
).
1
), COOL ( ),
button and wait
) rotation from