Maico MV 25 Instructions De Montage Et Mode D'emploi page 10

Motorschutzschalter / Motor
protection switch / Disjoncteur-
protecteur intégral MV 25
● Only connect the MV 25 to a permanent
electrical installation. Select cable type and
cross-section in accordance with DIN VDE
0298-4.
● A device for mains separation with at least
3 mm contact opening per pole and a fixed
electrical installation (connection according
to wiring diagram) is required.
● Operation is only permitted using the voltage
and frequency shown on the rating plate.
● Connect PE conductor and check the con-
nection.
● Test protective-conductor continuity on
housing.
● Only operate the unit when it is completely
installed.
● Modifications and alterations are not permit-
ted and release the manufacturer from any
guarantee obligations and liability.
● Do not take a damaged unit into operation
and do not allow it to be operated until
repaired.
● Store packaging material out of the reach of
children
DE
Risk of suffocation if swallowed.

UK
VENTILATOREN
FR