easymaxx XTB30-8 Mode D'emploi page 17

5. Pour detergent that is suitable for the textiles into the wash drum (4). Please note that
you require less detergent than in a conventional washing machine.
6. Close the lid (7).
7. Insert the mains plug into a properly installed 220 – 240 V plug socket.
Washing
8. Move the control dial (9) to Waschen (wash) and set the timer (1) to the time you
want (max. 15 minutes).
9. The device will start the wash cycle.
10. When the washing time is up, the device switches off automatically.
11. Allow the water to drain via the discharge hose (3) into a sink or similar outlet.
Rinsing
12. Fill the wash drum (4) again with clear water that is cold or lukewarm but do not add
any detergent to it.
13. Move the control dial (9) to Waschen (wash) and set the timer (1) to the time you
want (max. 15 minutes).
14. The device will start the rinse cycle.
15. When the rinsing time is up, the device switches off automatically.
16. Allow the water to drain via the discharge hose (3) into a sink or similar outlet.
Spinning
17. Open the lid (7) and take the wet laundry out of the wash drum (4).
17
Feed Hose
– Connect the feed hose to the socket (8) on the device.
– Plug the feed hose onto the tap adapter so that it cannot
slip off.
– Connect the feed hose to a tap using the adapter and
tighten the clip.
If the adapter does not fi t on your tap, you can also
simply hold the feed hose under the tap.
– Fill the wash drum (4) up to the MAX marking with clear
water at a temperature of no more than 60°C.
18. Place the wet laundry, divided up if necessary (max. 1.5
kg) into the spin drum (6) and then insert the cover again.
19. Place the spin drum (6) into the wash drum (4). Make sure
that it is seated correctly on the hub (A). To ensure that the
spin drum does not jump off the hub (A) while it is spin-
A
ning, the recesses in the bottom of the spin drum (6) must
be seated correctly on the mating parts on the hub (A).
EN