Chris Benz DEPTHMETER Chronograph 300M Mode D'emploi page 24

8. DIVING MODE
(A)
44
THE MAXIMUM DEPTH MEMO FUNCTION
This watch automatically records the maximum
depth reached during a dive (in 1 meter incre-
ments). This memo is retained until the watch
is set to the diving mode again and a depth of
1 meter or more is reached.
CALLING THE MAXIMUM DEPTH MEMO
While in the time mode or diving mode (a depth
of 0 is displayed) press button (A). The function
hand will display the maximum depth.
Pressing button (A) a second time or leaving
the memo displayed continuously for 30
seconds will release the maximum depth
memo display.
8. DIVING MODE
AUTO-RETURN-SYSTEM
The watch automatically returns to the
time mode if the function hand remains at
0 meter for longer than 30 minutes in the
diving mode.
ABNORMAL ACTIVATION PREVENTION FUNCT.
If the depthmeter is functioning abnormally
for some reason, the function hand will point
to the Over Zone Mark when the watch is
switched to the diving mode, and depth
measurement will not be possible.
In such a case, switch back to the time mode.
GENERAL
A depth less than 1 meter is not recorded.
The data in the maximum depth memo will
be cleared when the battery reaches the end
of its life. Be sure to record necessary memo
information in a log book.
The fi rst time this function is used, it may
display data that was used in product testing.
Depths over 50 meters will
be recorded as the Over Zone Mark.
45