Midi Bulk Dump - Viscount MIDI-Pedalboard Mode D'emploi

MIDI-Pedalboard
7) Press [C#3]
PEDALBOARD FUNCTION MODE (monofonic, polifonic, Program Change transmission)
1) Press [SET] button
2) Press [A#2]
3) Press:
- [C1] to set the polifonic mode
- [D1] to set the monofonic mode with priority of the last played note
- [E1] to set the monofonic mode with priority of the lower note
- [F1] to set the Program Change transmission mode (in this mode pedals don't transmit Midi note
but Program Change messages, see also par. "Note number or Program Change applied to the first
key"
4) Press [C#3]
Midi Bulk Dump is a data packet containing the instrument's configuration, i.e the values of the functions
already described Storing these datas into an external unit gives you the possibility to create and dispose
of several pedalbord's configurations. In addition you can create an external backup of the configuration.
TRANSMISSION
For transmitting on [MIDI OUT] port (connected to the Midi In port of a Midi device like a sequencer)
the pedalbord's configuration press [SET] button and then the [D3]. When finished the red Led will lights
off.
RECEPTION
For receiving and storing in the internal memory a Midi Bulk Dump previously transmitted and recorded,
connect the Midi Out of a Midi data player or a sequencer to Midi pedalboard's [INPUT 1] or [INPUT 2].
Then press [SET] button and start playing the recorded Midi Bulk Dump on the external Midi device.
When reception is terminated, the instrument will check datas (in order to avoid configuration problems).If
they are not correct, the red Led will flash twice.

5. MIDI BULK DUMP

19
EN