Instrument Configuration (Set Mode) - Viscount MIDI-Pedalboard Mode D'emploi

EN

3. INSTRUMENT CONFIGURATION (SET MODE)

For starting the instrument configuration functions, press [SET] button and the red Led will light. In
order to exit from the Set mode and to return to the play mode press again [SET] button and the red Led
light off.
NOTE
In Set mode the instrument does not transmit MIDI data.
In Set mode the pedals and the controls are used to input the data for device programming.
After having pressed [SET] button, you must first select the desired function using a black key and then
setting the data using the white keys. To complete and store the new configuration, you must press the
third C# ( in order to confirm the change).
If, having pressed the wrong key, it doesn't select the desired function, simply press the correct key for
recalling the function.
The Set mode contains the following configuration functions:
- [C#1]: unit for numeric data entry ( from 0 to 127)
- [D#1]: tens for numeric data entry (from 0 to 127)
- [F#1]: Midi transmission channel for the notes played on the pedalboard
- [G#1]: Midi velocity value of the notes played on the pedalboard
- [A#1]: Midi note or Program Change number of the first pedal -C1 (transposer function)
- [C#2]: Midi transmission channel for Control Change in connection with the expression pedal
[EXPR. 1]
- [D#2]: Midi transmission channel for Control Change in connection with the expression pedal
[EXPR. 2]
- [F#2]: function connected (type of Control Change transmitted) to the expression pedal [EXPR. 1]
- [G#2]: function connected (type of the Control Change transmitted) to the expression pedal
[EXPR. 2]
- [A#2]: pedalbord function mode selection
The procedure for setting numeric datas, (if not differently mentioned in this manual) is the following:
- values from 0 to 15: press a white pedal from [C1] to [D3] (C1=0)
- values from 0 to 127: press [C#1] ,then a white pedal from 0 to 9 to set the units; press [D#1] then
a white pedal between 0 and 12 to set the tens. Values higher than 127 are blocked to this value.
Once the data entry procedure is completed, press [C#3] to confirm (Enter function), the red Led will
light off and the pedalboard will go back to the standard mode. It is possible to set the desired number
several times before confirmation but only the last number will be accepted and stored.
16
MIDI-Pedalboard