Uline H-4455 Manuel

π
H-4455
MOBILE BLUEPRINT RACK
TOOLS NEEDED
11mm Wrench
Pivot Hanger x 12
Upper Rack x 1 Lower Spreader
PAGE 1 OF 6
1-800-295-5510
uline.com
Allen Wrench (Included)
Side Frame x 2
Bar x 1
ASSEMBLY
Figure 1
PARTS
End Cap x 2
Frame
Extension x 1
1. Position Frame Extension with holes toward the floor.
Insert Frame Extension into the short end of the Side
Frame tubes. (See Figure 1)
2. Slide posts of Upper Rack into the long end of the
Side Frame tubes. (See Figure 1)
3. Insert Knobs into upper part of Side Frames and
adjust to desired height. Insert Set Screws into lower
part of Side Frames and adjust to desired depth. Use
Allen Wrench to lock in position. (See Figure 1)
4. Attach Lower Spreader Bar to Side Frames using two
Screws. Fully tighten screws to secure bar in position.
(See Figure 1)
5. Install Casters to underside of frame by carefully
screwing them in. Position both Locking Casters at
the front of the frame by inserting into the frame
extension. (See Figure 1)
6. Insert End Caps into the Upper Rack. (See Figure 1)
Para Español, vea páginas 3-4.
Pour le français, consulter les pages 5-6.
Knob x 2
Swivel
Caster x 2
Screw x 2
Locking Swivel
Set Screw x 2 Caster x 2
0521 IH-4455