Uline H-4909 Instructions De Montage

H-4909, H-4905, H-4906
CONCRETE INSTALLATION KIT FOR
END OF RACK PROTECTORS
TOOLS NEEDED
3/4" Masonry
Drill Bit
Anchor Bolt x 4
1. Verify the rack protectors are positioned in the
desired location. Mark the floor where holes will
be drilled.
WARNING! Wear eye protection when
completing step 2.
2. Using a 3/4" diameter masonry drill bit, drill a hole
approximately 5" deep into the floor. (See Figure 1)
NOTE: For the anchor to function properly, the
hole must not be larger in diameter than the
anchor bolt.
3. Clean out debris and dust from inside the hole. Fully
insert the anchor bolt through the mounting plate and
into the hole.
4. Slightly tap down the anchor bolt with a hammer if
needed. Slide washer onto anchor bolt. Tighten the
hex nut until the anchor bolt is secure.
5. Repeat for remaining anchors.
PAGE 1 OF 3
1-800-295-5510
uline.com
Eye Protection
PARTS
Washer x 4
INSTALLATION
Figure 1
Washer
Anchor
3/4" Masonry
Drill Bit
Rack
Protector
Para Español, vea página 2.
Pour le français, consulter la page 3.
Hex Nut x 4
Nut
Bolt
0523 IH-4909