Maytag MDB8859AWB - Jetclean Plus 24 in. Dishwasher Instructions Utilisateur page 6

OPTIONS DISH LOAD TYPES DESCRIPTIONS USE WITH:
To sanitize your dishes and Raises the water temperature in the final rinse to Heavy Wash, Normal
glassware in accordance approximately 154°F (68°C). This high temperature rinse Wash, Light, Insta
with NSF/ANSI Standard sanitizes your dishes and glassware in accordance with Wash, or Auto Clean
184 for Residential NSF/ANSI Standard 184 for Residential Dishwashers. Plus
Dishwashers. Certified residential dishwashers are not intended for
licensed food establishments.
The Sanitize option adds heat and time to the cycle.
Use for ioads With normal Provides deep clean and shine bY adding steam to the cYclel Heavy, Normal, & Auto
amounts of food soils; Raises the Water temperature in the final rinSe to .................... C!ean P!us cyc!es ...........
............. speCiwa_eed°ptk_nf°r approximately !54°F (68°0).
g
cleaning.
Loads containing tough, Increases the target water temperature during the wash Heavy, Normal, & Auto
baked-on food. portions of the cycle. Clean Plus cycles
Adds heat, wash time and water to the cycle.
To run y.our dishwasher at DelaYs the start of a Cyc!e up t° 6 h0urs. A!! CYcles
L_2_J aater t me or dur ng off
_ , I - Select awash cycle and opt onsl Press Delay. Press START/
_ _, _ peak nours.
RESUME. Close the door f rmly.
Control Lock
@ locked
hold to lock
To avoid unintended use of
your dishwasher, or cycle
and option changes during
a cycle.
To turn on Lock, press and hold Heated Dry for at least
3 seconds.
To turn off Lock, press and hold Heated Dry for at least
3 seconds.
Anytime
When Control Lock is lit, all buttons are disabled. If you press
any pad while your dishwasher is locked, the light flashes
5 times. The dishwasher door can be opened while the
controls are locked.
IMPORTANT: The sensor in your dishwasher monitors the soil level. Cycle time and/or water usage can vary as the sensor adjusts the
cycle for the best wash performance. If the incoming water is less than the recommended temperature or food soils are heavy, the cycle
will automatically compensate by adding time, heat and water as needed.
CONTROL PURPOSE COMMENTS
start 0r iesume a If the door is opened during a cYcle oi the power is interrupted, all lights Wi!! flash to indicate a
wash cycle suspended cycle. The cycle will not resume until the door is closed and the START/RESUME
To cancel wash
cycle
Close the door firmly. The dishwasher starts a 2-minute drain (if needed). Let the dishwasher
drain completely.
cance_
drain
i'_an_ TOfollow the The !'C!ean!' indicator glows When a cyc!e is finished.
.... t,zed _
progress and status
! '. ,:. . if You Select the sanitize option; when the sanitize cYc!e is finished, the Sanitized indicator glows:
Of
your alsnwasner
Wash dry ceao c cle If your dishwasher did not properly sanitize your dishes the light will not come on. Thiscan
Y happen if the cycle is interrupted, or the water could not be heated to the required temperaturel
The clean and sanitize lights go off when the door has been opened for more than 30 seconds Or
the CANCEL key is pressed.
The ""Washing indicat0r glows at the start of th e first fill Of any cycle(expect Rinse Only)and
remains on unti! the end of the main wash cyclei
The "Drying"indicator glows during the drying portion of each cycle (expect Insta Wash and