Parkside PVA 20 LI-C2 Instructions D’origine page 27

To ensure full rechargeable battery
capacity, please fully charge your
battery pack before using this product
for the first time.
(* not included)
˜ Inserting/removing the
battery pack*
Inserting the battery pack
Push the battery pack
o
product . Snap the battery pack into
the battery slot
Removing the battery pack
Press the release button
o
remove the battery pack
(* not included)
˜ Checking the battery charge
level
Press the battery charge level
o
button to check the battery status .
[ 11 ]
The battery charge level is shown on
o
the battery display LED
Display LED Battery charge level
Red + Orange + maximum battery
Green charge level
Red + Orange medium battery
charge level
Red low battery charge
level (Charge the
battery pack
˜ Operation
˜ Switching on/off
Status Speed
level
1
On
2
Off -
24 GB/IE
into the
[ 8 ]
.
4 ] [
and
[ 9 ]
.
[ 8 ]
as follows:
[ 10 ]
. )
8 ] [
Position of the
on/off switch
I
II
0
˜ Adjusting the fan head
Turn the front grille
o
position .
˜ Carrying handle
Carry and transport the product by
o
the carrying handle
grille .
[ 1b ]
˜ Mounting the fan
This product can be mounted on
o
a horizontal position (e .g . work
bench) or vertical position (e.g. wall)
(Fig. C) with the four mounting holes
on the corners of the stand
6 ] [
using 4 pairs of mounting screws
and dowels (M6 x min. 30mm) (not
included).
Make sure that the fan is mounted
o
such that the fan operation is not
impeded .
˜ Fastening hook
Fold the hook
[ 5 ]
o
so that you can attach it to a suitable
place, such as a wall hook .
˜ Cleaning and maintenance
˜ Original accessories
Customers can obtain compatible
replacement batteries and chargers
from the LIDL online shop
www .lidl .de .
Only use accessories that are
specified in the user manual. The
use of accessories that are not
recommended in the user manual may
pose a risk of injury to you .
to the desired
1a ] [
on the rear
2 ] [
3 ] [
out of the stand
3 ] [