AEG A82630GNW3 Notice D'utilisation page 32

32 www.aeg.com
Problem
There is too much frost and
ice.
The compressor does not
start immediately after
pressing the FROSTMATIC,
or after changing the tem-
perature.
Water flows on the floor.
Temperature cannot be set.
DEMO appears on the dis-
play.
Door is misaligned or inter-
feres with ventilation grill.
The temperature in the ap-
pliance is too low/too high.
Possible cause
The door is not closed cor-
rectly.
The FROSTMATIC function
is switched on.
The door is not closed cor-
rectly or the gasket is de-
formed/dirty.
This is normal, no error has
occurred.
The melting water outlet is
not connected to the
evaporative tray above the
compressor.
The FROSTMATIC function
is switched on.
The appliance is in demon-
stration mode.
The appliance is not level-
led.
The temperature regulator
is not set correctly.
Food products placed in
the appliance were too
warm.
The door has been
opened often.
The FROSTMATIC function
is switched on.
There is no cold air circula-
tion in the appliance.
Solution
Refer to "Closing the door".
Refer to "FROSTMATIC func-
tion".
Refer to "Closing the door".
The compressor starts after a
period of time.
Attach the melting water out-
let to the evaporative tray.
Switch off FROSTMATIC man-
ually, or wait until the function
resets automatically to set the
temperature. Refer to
"FROSTMATIC function".
Keep the Mode pressed for
approximately 10 seconds un-
til a long sound is heard and
display shuts off for a short
time.
Refer to "Levelling".
Set a higher/lower tempera-
ture.
Allow food products to cool to
room temperature before stor-
ing.
Open the door only if necessa-
ry.
Refer to "FROSTMATIC func-
tion".
Make sure that there is cold air
circulation in the appliance.