Makita DCG180 Manuel D'instructions page 7

Lighting up the lamp
CAUTION:
Do not look in the light or see the source of light directly.
•
1
013570
Pull the switch trigger to light up the lamp. The lamp
keeps on lighting while the switch trigger is being pulled.
The lamp goes out approximately 10 seconds after the
switch trigger is released.
NOTE:
Use a dry cloth to wipe the dirt off the lens of lamp.
•
Be careful not to scratch the lens of lamp, or it
may lower the illumination.
When the tool is overheated, the lamp flickers.
•
Cool down the tool fully before operating again.
Drip preventive function
The motor keeps running for a short time even after the
trigger is released. It releases the pressure of the
caulking material and prevents dripping.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before carrying out
any work on the tool.
Always place the tool on the ground or workbench
•
when carrying out any assembling work. The tool
without being held tight may loose balance and
cause injury.
Installing holder joint
For short holder (300ml(18.3cu.in)) and long holder
(600ml(36.6cu.in))
013610
1. Lamp
7
Attach the holder joint firmly along the tool, set the plate,
and fix them with screws tightly.
For big holder (800ml(48.8cu.in))
015611
Attach the holder joint firmly along the tool, and fix them
with screws tightly.
To remove the holder joint, follow above procedure in
reverse.
NOTE:
There are three types of holders (optional
•
accessory), short holder (300ml(18.3cu.in)), long
holder (600ml(36.6cu.in)),
(800ml(48.8cu.in)).
accordingly.
Installing rod and piston
For short holder (300ml(18.3cu.in))
A
015608
For long holder (600ml(36.6cu.in))
A
B
C
013612
and big
Use appropriate holder joint
holder