Decommissioning And Care / Warranty - Kränzle UFO 300 Manuel D'utilisation

12
Decommissioning and care
GB
Decommissioning
1. Switch off HP-cleaner
2. Cut off the water supply
3. Open the spray gun briefly until the pressure is released
4. Apply the safety catch on the spray gun
5. Remove Kränzle roundcleaner
6. Check if the rotor is tangled with threads etc.
7. Use a paper clip to check if the nozzles are clogged (see page 14)
Cleaning and care
Put the RoundCleaner onto the floor in such a way that the splash protection flaps
cannot be deformed due to rough ground.
The Kränzle RoundCleaner UFO can be operated with hot
water of max. 60 °C. Attention! Danger of scalding!
Only touch metal parts wearing gauntlets.
Make sure to wear protective clothng!
Warranty
This warranty covers material and/or workmanship related defects only and does not
extend to ordinary wear.
Machine must be operated according to enclosed operating instructions which are part
of present warranty conditions.
Machines sold directly to private customers are warrantied for a period of 24 months,
whereas the warranty period for industrial purchases is limited to 12 months.
In case of any warranty claims, please have accessories and your purchase document
ready and contact your nearest dealer or authorized service point which can also be
looked up in the internet at www.kraenzle.com .
Warranty is void in case of attempts to modify any of the safety devices or in the event
of exceeding temperature limits - this also applies to low water and/or polluted water as
well as changes/modifications to the tilting angle of the nozzles.
Nozzles, sealing sleeves, inlet hose, sliding brush, splash protection and housing are
considered wear parts and do not fall under this warranty.