General Control - Sharp Ps-935 Manuel De Fonctionnement

General control

To turn the power on or off
■
Press the power ON/OFF switch to turn the unit
on/off.
Note:
In USB / Bluetooth / AUDIO IN mode, when the unit
is not receiving any signal for around 15 minutes, it
will automatically switch into standby mode. Press
the INPUT / STAND-BY button to turn on the unit
again.
Please note that low volume setting in the audio
source may be recognized as "no audio signal".
This will affect the capability of signal detection
from the device and can also originate an automatic
switch into standby mode. If this happens please
reactivate the audio signal transmission or increase
the volume setting on the audio source player in
order to resume playback.
Input / Standby mode
■
To change the function modes, press the INPUT/
STAND-BY button repeatedly.
BLUETOOTH
TUNER
Volume control
■
Rotate the VOLUME +/- knob on the unit
to increase or decrease the music volume.
Microphone volume control
■
Rotate the MIC VOL.+/- knob on the unit to increase
or decrease the microphone volume.
Bass and Treble level control
■
Rotate the BASS or TREBLE knob on the unit to
increase or decrease the bass or treble effect.
Microphone ECHO control
■
Rotate the ECHO knob on the unit to increase or
decrease the microphone echo level.
PS935_IM_EN.indd 11 PS935_IM_EN.indd 11
USB
AUDIO IN (AUX IN)
Microphone Priority mode
■
Press the button to enable the Microphone priority
ON, the music would turn lower when voice is
detected at the microphone.
Flashing light
■
There are 8 modes for the DISCO LED lighting.
Press the LIGHT button to choose the light modes
L-01 L-02
L OFF L-08
E-11
L-03 L-04 L-05
L-07 L-06
6/26/23 4:19 PM 6/26/23 4:19 PM