Preparation; Locating Your Electric Fireplace; Installation Instructions - ChimneyFree 35HF500GRA-BLK Manuel D'instruction

PREPARATION

Before beginning installation of product, make sure all parts are present. Compare parts with
package contents list and diagram above. If any part is missing or damaged, do not attempt to
assemble, install or operate the product. Contact customer service for replacement parts.
Estimated Assembly Time: 15 minutes
Tools Required for Assembly (not included): Phillips screwdriver, Drill, Hammer
WARNING! Do not use this electric fireplace if any part has
been under water. Immediately call a qualified service
technician to inspect and to replace any part of the electrical
system if necessary. Keep plastic wrapping away from children.
• Open the packaging carefully and remove the foam.
• Remove and discard the plastic bag.
• Be responsible when handling the packing materials.
• Keep the original packaging for future transport and/or storage.
• Check that all accessories are removed before you discard the packing.

LOCATING YOUR ELECTRIC FIREPLACE

Your new electric fireplace may be installed virtually anywhere in your home. However, when
choosing a location ensure that the general instructions are followed. For best results, install out of
direct sunlight. Power supply service must be either completed or placed within the electric fireplace
prior to finishing to avoid reconstruction.
CAUTION: Set the power cord as pictured below:
Heat Outlet
WARNING: Keep drapery and other furnishings
at least 3 ft. from the front and sides of the
electric fireplace.
Clearance to combustibles
Sides ..........................................................2 in.
Floor .....................................................11.75 in.
Top ..............................................................0 in.
Back ............................................................0 in.

INSTALLATION INSTRUCTIONS

1. Choose a solid wall surface to attach
the mounting bracket (A). Position the
mounting bracket (A) in the desired location
and mark the four holes with a pencil (Fig. 1).
Cable
min.
Cable
Heat Outlet
50 mm
2 in.
FLOOR
Fig. 1
6
50 mm
min.
2 in.
min. 300 mm
11 3/4 in.