Timbertech RSSR01 Mode D'emploi Original page 56

Middle line
Turn the gearwheel so that the metal cam of the gear unit is orientated perpendicularly to the
middle line. (See the above figures)
Hole
Middle line
Move the upper blade of the blade assembly so that the middle line of the metal ring aligns exactly
with the center of the hole. (See in the above figure)
Guide the bottom edge of the blade assembly into the corresponding locking holes of the gear
unit. Then press the two protrusions of the gear unit into the locking holes of the blade assembly.
Make sure that the cam of the gearwheel snaps into the metal ring entirely.
Gear wheel
Marking rib
Bottom blade
56
EN
Marking rib
Upper blade
Metal ring
Gear wheel
Middle line