Technical Data - Nuova Battipav Super Pro 3045 Mode D'emploi

GB

Technical Data

Art. 3045 Art. 3060
Cutting length
450 mm 600 mm
Max. tile size
31x31 cm 42x42 cm
Weight
13 Kg 16 Kg
Cutting thickness:
Tool:
TUNGSTEN CARBIDE WHEEL
Tool diameter:
Intended use:
CERAMICS, SINGLE-FIRED TILES, GRES,
KLINKER, TERRACOTTA AND MARBLE.
1. Use
CAUTION !
All our tools undergo a series of tests and are
carefully checked before they leave our factory.
NUOVA BATTIPAV is constantly involved in
developing the equipment we supply.
therefore reserve the right to make any changes
we deem necessary. No demands may therefore
be made on the basis of the information and
illustrations found in this manual.
The SUPER PRO tile cutter is a tool that is
technologically advanced and that offers high
performance. It is suitable for cutting ceramic
materials.
2. Warning
• The manufacturer accepts no responsibility for
SUPER PRO tile cutters used with other tools,
or for cutting any materials other than those
indicated in the "INTENDED USE" paragraph.
Art. 3075 Art. 3090
750 mm 900 mm
52x52 cm 63x63 cm
19 Kg 22 Kg
5-19 mm
Art. 492
Ø22x6,1x4,7 mm
We
3. Assembly
Remove the tool from its packing and check that no
part of it has been damaged. Assemble your
SUPER PRO tile cutter to suit the type of use you
require.
RIGHT HANDED OPERATORS
a) Set up the carriage rod on the worktable as
indicated in photo 1.
Secure the carriage rod unit using the screws
supplied.
1
b) Remove the tile-supporting rod (Exploded view,
Pos. 10 - Art. 30092) by removing the two M6
nuts using the 10 mm Allen wrench.
c) Position the tile support rod at the front of the
worktable by inserting the screws in the relevant
holes in the worktable (photo 2).
d) Then tighten the nuts using the 10 mm Allen
wrench (photo 2).
CHECK THAT THE CUTTING TOOL IS
ALIGNED AT 0 CM FROM THE SQUARE
SUPPORTING ROD
2
8