Routine Maintenance - Nuova Battipav Super Pro 3045 Mode D'emploi

GB
c) Position the breaking foot using the side levers
on the carriage (photo 7).
d) Then exert a gradually increasing pressure until
the tile is separated (photo 7).
Use the graduated rods and the adjustable square
for repetitive cuts and / or specific cutting angles.
7
CAUTION !
WHEN WORKING WITH HARD TILES, IT IS
ADVISABLE TO PRESS THE BREAKING FOOT
AGAINST ONE END OF THE TILE UNTIL IT
STARTS TO SEPARATE. COMPLETE THE
BREAK BY PRESSING ON THE OTHER END.

5. Routine maintenance

CAUTION !
a) Remove any encrustation or residue from the
carriage rod, without lubricating it.
b) Adjust the cutting wheel by tightening the 3 mm
male hexagonal-headed screw using the
wrench supplied, to remove any lateral play,
without blocking it (photo 8).
8
c) Remove all vertical play on the carriage by
tightening the screw indicated (photo 9), using
the 2,5 mm Allen wrench provided.
9
d) Remove all lateral play on the carriage by
tightening the screws indicated (photo 10),
using the 2 mm Allen wrench provided.
10
EXCESSIVE ADJUSTMENT OF THE SCREWS
WILL PREVENT THE CUTTING CARRIAGE
SLIDING PROPERLY.
e) When required, lubricate the vertical sliding
seating on the H-shaped support for the foot
(photo 11).
11
10