Fanaway LD-0003-10/WH/GS/E27 Guide D'installation page 9

BUTTONS ON THE REMOTE
FAN AUTO: Press the button to switch from FAN AUTO mode to MANAUL mode.
FAN: Press the button to set fan running at HIGH – MEDIUM – LOW – OFF speed.
FAN TIMER: Press the button to turn off the fan at setting time automatically.
LIGHT TIMER: Press the button to turn off the light at setting time automatically.
Press and hold the button for 10 seconds to switch from degree Celsius to degree Fahrenheit.
LIGHT DELAY: Press the button to active the light delay function, which will turn off the light 3 minutes later.
Up: Set the temperature and time up
Down: Set the temperature and time down
LIGHT switch: Press the button to turn ON/ OFF the light.
Use the FAN AUTO Function
Press the FAN AUTO button to active FAN AUTO function, and then press the UP/ DOWN buttons to set the
temperature at what you preferred. The fan will run at the HIGH, MEDIUM, LOW or OFF speed automatically
via comparing to room temperature as following:
Room temperature is lower than setting temperature: ------------------> OFF
Room temperature is higher than setting temperature by 0˚ C -------> LOW
Room temperature is higher than setting temperature by 2˚ C -------> MED
Room temperature is higher than setting temperature by 4˚ C -------> HI
Press the FAN AUTO button again to turn off the FAN AUTO function.
Use FAN/ LIGHT TIMER Function
Press the FAN TIMER / LIGHT TIMER buttons to active the timer function, and then press the UP / DOWN
buttons to set the time at what you preferred. The fan and light will turn OFF at setting time.
9