Troubleshooting Tips - Midea Mad22C3Wmt Passeport Technique

Troubleshooting Tips

Before calling for service, review this list. It may save you time and money. This list
includes common occurrences that are not the result of defective workmanship or
materials in this appliance.
Problem Solution
Make sure the dehumidifiers plug is connected firmly into the wall outlet.
Check the house fuse/circuit breaker box.
Unit does not
start
Dehumidifier has reached its preset level or bucket is full.
Water bucket is not in the proper position.
Not enough time to remove the moisture.
Make sure there are no curtains, blinds or furniture blocking the front
Dehumidifier
or back of the dehumidifier.
does not dry
The humidity control may not be set low enough.
the air as it
Check that all doors, windows and other openings are securely closed.
should
Room temperature is too low, below 5°C (41°F).
There is a water vapor source in the room.
Air filter may be dirty. Clean filter. Refer to Care and Cleaning section.
The unit makes
a loud noise The unit is tilted instead of upright as it should be.
when operating
The floor surface is not level.
Frost appears
This is normal. The dehumidifier has Auto defrost feature.
on the coils
Hose to connector or hose connection may be loose.
Water on floor
Intended to use the bucket to collect water, but the back drain plug is
removed.
ES, AS, P2,
EC, Eb and E3 These are error codes and protection code. Check Operating
appear in the Instructions.
display
The pump Clean the pump filter.
operation on
Check the pump hose is not blocked or leaking.
light blinks at
Empty the water bucket.
1 Hz
Page 21