GE PDWT400R1OWW Manuel Du Propriétaire page 7

About the dishwasher control panel.
D Enhancements
The light above the selected pad will be ON to indicate which ENHANCEMENT has been selected.
DELAY HOURS
You can delay the start of a wash cycle for up to 2/4hours (depending on model).
Pressthe DELAYSTART pad to choose the number of hours you want to delay the start
of the cycle; then press START/RESET.
Front-Control Dishwashers: The machine will count down and start automatically
at the correct time.
TEMP BOOST/
ADDED HEAT/
EXTRA HOT WASH
STEAM PRE-WASH/
PRE-WASH
(on some models)
HEATEDDRY
Light Off
HEATEDDRY
Light On
LOCK
RESET
El
Top-Control Dishwashers:After closing the door,the machine will count down
and automatically start at the correct time.
NOTE:To cancel the DELAYSTART selection before the cycle begins, repeatedly press
the DELAYSTART pad until the display is blank.
When selected, the cycle will run longer with heating element on to improve both wash
and dry performance.
NOTE:Cannot be selected with RINSEANDHOLD cycle.
For use with heavily soiled and/or dried-on, baked-on soils.This option MUSTbe
selected PRIORto starting the cycle. The PRE-WASHoption adds 15 minutes
and the STEAMPRE-WASHoption adds 2/4minutes to the cycle time.
NOTE:Cannot be selected with RINSEANDHOLD cycle.
Shuts offthe drying heat option. Disheswill air dry naturally (Front-Control
Dishwashers)or fan dry (Top-Control Dishwashers)to save energy.
Turns the heater on for fast drying. This will extend the total cycle time by/45 minutes
for the NORMALcycle, 58 minutes for the TOPRACKONLYand COOKWARE cycles,
]2 minutes for the DEEPCLEANcycle, 15 minutes for the ANTI-BACTERIA and
PLASTICS cycles, and 30 minutes for all other cycles.
You can lock the controls to prevent any selections from being made. Or you can lock
the controls after you hove started a cycle.
Children cannot accidentally start dishwasher by touching pads with this option
selected.
To unlock the dishwasher controls, press and hold the HEATEDDRY pad for 3 seconds.
The light above the lock pad will turn off. To lock the dishwasher, press and hold the
HEATEDDRY pad for 3 seconds.The light above the LOCKpad will turn on.
To change a cycle after washing starts...
Front-Control Dishwashers: Touch the START/RESET pad to cancel the cycle.
TheSTART/RESETlight will flash while the water is pumped out if needed.This takes
approximately 2 minutes.
Top-Control Dishwashers: Open the door slowly to prevent splash-out.
Touch the START/RESET p ad to cancel the cycle. If the START/RESET l ight is flashing,
close the door until the water pumps out (this takes approximately 2 minutes)
and the light stops flashing.
When the light stops flashing, the dishwasher can be reprogrammed and restarted.
Start
Front-Control Dishwashers
Close and latch the dishwasher door and select the cycle and desired enhancements. Touch the
START/RESET p ad to begin the cycle. Water fill begins immediately, and approximately 60 seconds later
the wash action begins.
When the dishwasher door is fully closed and latched, the control panel lights will display the lost settings
you selected. If you don't wont to change any of the settings, simply touch the START/RESET p ad to
begin the cycle.
If the door is closed,the indicator lights will turn off if the START/RESET p ad is not selectedwithin 5 minutes.
To activate the display, open and close the door or press any pad.