Wiring To Power Supply - Dcs 221712 Installation Guide

INSTALLATION

WIRING TO POWER SUPPLY

WARNING:
Turn off power circuit at the service panel before wiring this unit.
120 VAC, 15 Amp circuit required.
1. Remove j-box cover as shown in Fig. 14.
2. Remove the knockout and install the strain relief (conduit) connector (1/2") in junction box.
3. Run 3 wires; black, white and green (#14 AWG) in 1/2" conduit from service panel to junction box.
4. Connect black wire from service panel to black or red in junction box, white to white and green
to green-yellow. See Fig. 14.
5. Close junction box cover.
6. Plug cable at the top of the hood into the junction box connector.
7. Check all light bulbs to make sure they are secure in their sockets, then turn power on in service
panel and check lights and blower operation per Care & Use manual and install drip tray support
and filters.
1/2"
Conduit
Junction
Box
From Control
Panel
FIG. 14
13
Junction
Box
Cover