cecotec 04946 Manuel D'instructions page 67

The robot vacuum cleaner could not
connect to the Wi-Fi network
The robot vacuum cleaner did not
carry out the scheduled cleaning
task
The robot vacuum cleaner does not
return to the self-emptying base
after finishing Spot cleaning or
changing the starting position
The robot vacuum cleaner does not
resume cleaning
The robot vacuum cleaner is always
offline
Bad Wi-Fi signal. Check that the robot vacuum
cleaner is located in an area with good Wi-Fi signal.
The Wi-Fi connection is unstable. Reset the router,
check if there are any App updates, and try again.
This robot vacuum cleaner only supports the 2.4
GHz band.
Make sure that your smartphone mobile data are
disabled to improve the linking process.
Check if the robot vacuum cleaner is in Sleep mode
and change mode. This option can be found on the
general settings of the robot vacuum cleaner and
allows you to define time slots in which the robot
will not perform the scheduled cleaning tasks
when in Sleep mode.
Ensure proper connection of the robot vacuum
cleaner to the Wi-Fi: you will not be able to carry
out scheduled cleaning without connection and
with a low battery.
The robot vacuum cleaner will map and calculate a
new route after running in Spot cleaning mode or
after changing its starting position.
If the self-emptying base is too far away from the
robot vacuum cleaner, the latter won't be able
to return to the base. Manually move the robot
vacuum cleaner close to the self-emptying base.
Make sure the robot vacuum cleaner is not in Sleep
mode, as it will not resume cleaning in this mode.
When manually placed in the self-emptying base,
the robot will not resume cleaning.
Make sure the robot vacuum cleaner is successfully
connected to a 2.4 GHz network and always in
areas with good Wi-Fi signal.
Conga 7490 Immortal Home 6 Pack
ENGLISH
67